Menu
Cornell researchers print 3D speaker

Cornell researchers print 3D speaker

The fully-functional speaker is one of the first 3D-printed electronics products

Graduate student Apoorva Kiran working on his 3D printed, fully functional loudspeaker at Cornell University.

Graduate student Apoorva Kiran working on his 3D printed, fully functional loudspeaker at Cornell University.

Researchers at Cornell University have successfully fabricated a working loudspeaker using a 3D printer.

Their work represents one of the first times a complete electronics device has been printed from scratch to a working product.

As its name suggests, a 3D printer is capable of printing in a third dimension, layering upwards from a base material in additional to the two dimensional flat printing we are all used to. Rather than ink, it uses materials like plastic. Developers believe it could one day enable people to print small products, components and devices in their home.

The speaker's plastic body, conductive coil and magnet were all printed using a "Fab@Homes" printer at the university and the speaker was almost ready for use as soon as printing was finished, the university said.

The Fab@Home is a research printer that was developed by two Cornell students to help researchers experiment with 3D printing. One of the developers, Apoorva Kiran, a graduate student in mechanical engineering, worked with fellow student Robert MacCurdy on the speaker.

The ability to print components like speakers using a home printer is one of the promises of future 3D printing technology, but it's not here yet.

Conventional printers are unsuitable for 3D printing and among 3D printers that are just beginning to come to market, many don't have the capability to print with different materials. Fabricating a single device also requires the selection of materials that work well together, according to Cornell. Conductive coil and copper and plastic coming out of the same printer require different temperatures and curing times, it said.

Research into 3D printing is still in its early stages.

A recent report by Gartner predicted that the market for sub-$100,000 3D printers will grow 49 percent this year to 56,507 units on the back of rapid increases in quality. For 2014, Gartner expects the market will jump by around 75 percent to just over 98,000 units and that shipments will almost double again in 2015.

Martyn Williams covers mobile telecoms, Silicon Valley and general technology breaking news for The IDG News Service. Follow Martyn on Twitter at @martyn_williams. Martyn's e-mail address is martyn_williams@idg.com


Follow Us

Join the newsletter!

Or
Error: Please check your email address.

Tags Printerspopular scienceperipheralsCornell University

Featured

Slideshows

Bumper channel crowd kicks off first After Hours of 2018

Bumper channel crowd kicks off first After Hours of 2018

After Hours made a welcome return to the channel social calendar with a bumper crowd of partners, distributors and vendors descending on The Jefferson in Auckland to kick-start 2018. Photos by Gino Demeer.

Bumper channel crowd kicks off first After Hours of 2018
Looking back at the top 15 M&A deals in NZ during 2017

Looking back at the top 15 M&A deals in NZ during 2017

In 2017, merger and acquisitions fever reached new heights in New Zealand, with a host of big name deals dominating the headlines. Reseller News recaps the most important transactions of the Kiwi channel during the past 12 months.

Looking back at the top 15 M&A deals in NZ during 2017
Kiwi channel closes 2017 with After Hours

Kiwi channel closes 2017 with After Hours

The channel in New Zealand came together to celebrate the close of 2017, as the final After Hours played out in front of a bumper Auckland crowd.

Kiwi channel closes 2017 with After Hours
Show Comments